Loading ...
Loading ...
Loading ...
en Troubleshooting
28
Fault Cause and troubleshooting
Tableware is not dry. Water collects in recesses of the tableware or cutlery.
▶
Position tableware at an angle where possible.
The combined detergent used has a poor drying performance.
1.
Use rinse aid to improve drying performance.
2.
Use a different combined detergent with a better drying performance.
Extra Dry not activated to improve drying performance.
▶
Activate Extra Dry.
Tableware removed too early or drying process not yet ended.
1.
Wait until the programme ends.
2.
Only remove tableware 30minutes after the programme has ended.
Rinse aid used has a limited drying performance.
▶
Use a name-brand rinse aid.
Eco products may have limited effectiveness.
Plastic tableware is not dry. Not a fault. As plastic does not store heat so well, it also does not dry as well.
▶
No remedial action possible.
Cutlery is not dry. Cutlery not arranged properly in the cutlery basket or cutlery drawer.
1.
Arrange the cutlery properly.
→"Arrange tableware", Page20
2.
Arrange cutlery individually where possible.
3.
Avoid points of contact.
Appliance interior still wet after
wash cycle.
Not a fault. The condensation drying principle causes water droplets in the tub –
they are indeed desirable here. The moisture in the air condenses on the inside
walls, runs off and is pumped out.
No action required.
Remnants of food on tableware. Tableware was placed too close together.
1.
Arrange tableware with sufficient space in between.
The spray jets must reach the surfaces of the tableware.
2.
Avoid points of contact.
Basket is overfilled.
1.
Arrange tableware with sufficient space in between.
The spray jets must reach the surfaces of the tableware.
2.
Avoid points of contact.
Spray arm rotation is blocked.
▶
Arrange tableware so that it does not obstruct spray arm rotation.
Spray arm nozzles are blocked.
▶
Clean the "Spray arms" →Page25.
Filters are soiled.
▶
Clean the filters.
→"Cleaning filters", Page24
Loading ...
Loading ...
Loading ...