SEATED LEG CURL-EXTENSION User Manual

Loading ...

7. Install screw and washer securing the thigh pad assembly to the pivot boom assembly using a 7mm Allen wrench.

Item Description Qty.

1 Thigh Pad Assembly 1

2 Pivot Boom Assembly 1

3 Screw, M10 x 1.5, 30mm Low Head 1

4 Washer, Flat 30mm 1

5 Bearing Housing Cap 1

Tighten hardware to 14-16  (19-21.7 Nm).

8. Install bearing housing cap to the pivot boom assembly using a rubber mallet.

Cable Routing

1. Route cable out through the hole on the side of the tower frame. Route cable through the pulley support assembly.

2. Slide the carriage bolt to the end of the slot in the pulley support assembly using a 17mm wrench.

Item Description Qty.

1 Carriage Bolt, M10 x 1.5, 50mm 1

Tighten hardware to 20-25  (27.1-33.9 Nm).

3. Slide pulley support assembly onto the pivot  and align with holes in the tower frame.

NOTE: Press the pivot  into the pulley arm assembly so approximately ¼" is exposed to get the pulley support assembly to

align with the tower frame.

Page 24 of 40

Loading ...

Cybex SEATED LEG CURL-EXTENSION Ion Dual Stations