Loading ...
Loading ...
Loading ...
6. Install screws, washers, spacers, and nuts securing the pulleys to the top of the tower frame using an 8mm Allen wrench and
17mm wrench.
NOTE: Make sure the spacers are centered and inside the tube wall.
Item Description Qty.
1 Pulley, 3.5" OD 1
2 Pulley, 4.5" OD 1
3 Cable 1
4 Screw, M10 x 1.5, 55mm 2
5 Nut, M10 x 1.5, Hex Nylock 2
6 Washer, Flat 3/8" ID 4
7 Bushing 4
Tighten hardware to 14-16 (19-21.7 Nm).
NOTE: Make sure cable is routed over the pulleys and underneath the pins in the tower frame.
7. Flex rear shroud into position inside the tower frame.
Page 17 of 40
Loading ...
Loading ...
Loading ...