Loading ...
Loading ...
Loading ...
©2012-2015 DJI. All Rights Reserved. - 37 -
Tips:
For A2, set F channels function through the following four methods:
“Advanced” of A2 Assistant
“RC” of A2 Assistant
“F_ChannelController”
of Ground Station
“GP Servo Action Config”
of Ground Station
F1
Landing gear (mapping
required)
Mapping
Click to enable
N.A.
F2
Servo and gimbal
Mapping
Click to enable
Click to enable
F3
Mapping
Click to enable
N.A.
F4
Parachute
Mapping
Click to enable
N.A.
When you set the F channels function through methods above, the priority of F1~F4 output channels
function is as follows:
“Advanced” of A2 Assistant > “RC” of A2 Assistant > “F_ChannelController” of Ground Station > “GP
Servo Action Config” of Ground Station.
Using the F2 channel for example: If you enable “RC” in the A2 Assistant and F2 in “GP Servo Action
Config” of the Ground Station at the same time, the mapped function for F2 output channel has the higher
priority.
Way point Action Editing
Find and set the waypoint action properties according to the following procedures:
1. Click , the Mission Status will show Editing Mission label upon the Mission Editor.
2. Edit flight mission.
3. Select the waypoint either in 3D-Map or in the EditingMission menu, and get Waypoint action,
shown as Fig..
4. Give the proper parameters explained in Editor: Period, RepeatTime, StartDelay, and
RepeatDistance. Set RepeatTime and RepeatDistance zero to disable the GP-Servo Action.
Tips:
Use SetAllActioninMission properties to setup the sequence interval. For example: 0 means action
property is applied to no waypoint; 1 means action property is applied to every waypoint; 2 means action
property is applied to every two waypoints; 3 means action property is applied to every three waypoints,
etc.
Loading ...
Loading ...
Loading ...