Loading ...
Loading ...
Loading ...
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
DOORS AND LEVELING
Doors are difficult to open
Doors will not close completely
Doors appear to be uneven
Refrigerator rocks
and is not stable
Possible Causes and/or Recommended Solutions
• Gaskets are dirty or sticky - Clean the gaskets and contact surfaces with mild soap and warm water. Rinse and
dry with a soft cloth.
• Door is blocked open - Move food packages away from the door. Make sure all bins and shelves are in their
correct positions. Make sure all packaging materials have been removed.
• Doors need to be aligned, or refrigerator needs to be leveled - See the leveling and door alignment instructions.
• Refrigerator is not level - To stabilize the refrigerator, remove the base grille and lower the leveling feet until
they touch the floor. See the leveling and door alignment instructions.
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
ICE AND WATER
Ice maker is not
producing ice,
not producing enough ice,
or producing
small/hollow ice
Possible Causes and/or Recommended Solutions
• Refrigerator is not connected to a water supply, or the water supply shutoff valve is not fully turned on - Connect the
refrigerator to a water supply and make sure the water shutoff valve is fully open.
• Kink in the water source line - A kink in the water line can reduce water flow, resulting in decreased ice production,
small ice cubes, and/or hollow or irregularly-shaped ice. Straighten the water line.
• Ice maker is not turned on - Turn on the ice maker. See "ice Maker and Storage Bin."
• New installation - After connecting the refrigerator to a water source, flush the water system. (See "Water and Ice
Dispensers.") Wait 24 hours for ice production to begin. Wait 72 hours for full ice production. Discard the first three
batches of ice produced.
• Large amount of ice was recently removed - Allow sufficient time for the ice maker to produce more ice.
• Ice is jammed in the ice maker ejector arm (on some models) - Remove ice from the ejector arm using a plastic utensil.
• Inadequate water pressure - Verify that the household has adequate water pressure. See "Water Supply
Requirements."
• Water filter is installed incorrectly - Make sure the filter is properly installed. See "Water Filtration System."
• A reverse osmosis water filtration system is connected to your cold water supply - This can decrease water pressure. See
"Water Supply Requirements."
NOTE: If questions remain regarding water pressure, contact a licensed, qualified plumber.
24
Loading ...
Loading ...
Loading ...