Loading ...
Loading ...
Loading ...
Driving
not apply it directly unless very briefly and
al
ways from a distance of more than 10 cm.
●
A registration plate or plate holder on the
front with larger than the space for the reg-
istration plate, or a registration plate that is
curved or warped can cause:
–
False detections.
–
The sensors to lose visibility.
–
Cancellation of the parking manoeuvre
or defective parking.
●
If one of the ultrasonic sensors is dam-
aged, the area corresponding to that group
of sensors (front or rear) is deactivated and
cannot be activated until the fault is cor-
rected. However, you can still use the sen-
sors of the other bumper as per usual. If
there is a fault in the system, consult a spe-
cialist workshop. SEAT recommends visiting
a SEAT dealership for this.
Note
●
In or
der to guarantee good system oper-
ation, keep the ultrasound sensors of the
bumper clean, free of snow or ice, and do
not cover them with adhesives or other ob-
jects.
●
Certain sources of noise, such as rough
asphalt or paving stones and the noise of
other vehicles can induce the Park Assist
system or ParkPilot to give erroneous warn-
ings. The presence of metal objects can al-
so affect the manoeuvre.
●
In or
der to become familiar with the sys-
tem and its functions, SEAT recommends
that you practice operating the Park Assist
system in an area where there is not too
much traffic or in a car park.
Description of the parking assist
syst
em
The components of the Park Assist system
ar
e the ultrasonic sensors located in the front
and rear bumpers, the to switch the sys-
tem on and off and the messages on the in-
strument cluster display.
Prerequisites for parking
●
The traction control (TCS) must be switch-
ed on
›
››
page 277.
●
Speed when passing next to the parking
space: do not exceed approx. 50 km/h (31
mph).
●
Keep a distance between 0.5 and 2.0 me-
tres when driving past the parking space.
●
Space length (parallel parking): vehicle
length + 0.8 meters.
●
Space width (angle parking): vehicle width
+ 0.8 meters.
●
Do not exceed approximately 7 km/h
(4 mph) when parking. The vehicle will per-
form an automatic braking only once if this
speed is exceeded. If you exceed the speed
more than once, the Park Assist system
switches off.
Requirements for leaving the parking
space (only for parallel parking)
●
The traction control (TCS) must be switch-
ed on
›››
page 277.
●
Space length: length of the vehicle + 0.5
metres.
●
Do not exceed approximately 7 km/h
(4 mph) when exiting the parking space.
Prematurely stopping or automatically in-
terrupting the manoeuvres for parking or
exiting a parking space
Park Assist interrupts the manoeuvres for
parking or exiting a parking space in any of
the following cases:
●
Press button in the infotainment system,
> Assistants > Parking > Park assist sys-
tem.
●
When exceeding a speed of approximately
7 km/h (4 mph) more than once.
●
The driver takes control of the steering
wheel.
●
The parking manoeuvre does not end within
6 minutes from the activation of automatic
steering.
●
There is a fault in the system (the system is
temporarily unavailable).
280
Loading ...
Loading ...
Loading ...