Loading ...
Loading ...
Loading ...
Operation
Fitting the net partition
●
Fold the rear seat backrests forward.
●
Remove the net partition from the side sup-
ports.
●
Place the net casing in the rail slots in the
dir
ection of the arrows
›››
Fig. 141
1
.
●
Push the casing towards the left side of the
v
ehicle in the direction of arrow
›››
Fig. 141
2
and as far as it will go.
●
Check that the net is secure.
Pulling out and securing the net par
tition
●
Pull up handle
›››
Fig. 142
2
to remove the
net fr
om the casing
›››
Fig. 142
4
.
●
Hook in the net partition on the right or left
side
›
››
Fig. 142
3
(magnified image).
●
Hook in the net partition into the housing on
the other side
›
››
Fig. 142
1
by pulling the
r
od.
The net partition is properly assembled when
the T-shaped ends are firmly secured in the
corresponding housings
›››
Fig. 142
3
and
1
.
R
etracting the net partition
●
Remove the rod from the housings in the
trims of the roof side members.
●
Roll up the net into the casing
›››
Fig. 142
4
lowering it with your hand.
Removing the net partition
●
Pull the net casing out approximately 5 cm
in the opposit
e direction to the arrow
›››
Fig. 141
2
.
●
Remove the casing from the rails by pulling
in the opposit
e direction to the arrows
›››
Fig. 141
1
.
●
Lift the rear seat backrests.
WARNING
During a sudden driving or braking ma-
noeuvr
e, or in the event of an accident, ob-
jects could be flung though the interior and
cause serious or fatal injuries.
●
Always secure objects, even when the
net partition is properly assembled.
●
There should be nobody behind the as-
sembled partition when the vehicle is mov-
ing.
WARNING
The rear seat backrests should only be lif-
t
ed again once the net partition has been
disassembled.
CAUTION
Incorrect handling of the net partition
coul
d cause damage.
●
Do not “release” the net partition when
lowering it, as the net and other vehicle
parts could be damaged. Roll down the net
par
tition by hand.
Roof carrier
Intr
oduction
The vehicle roof has been designed to opti-
mise aer
odynamics. For this reason, cross
bars or conventional roof carrier systems
cannot be secured to the roof water drains.
As the roof water drains are integrated in the
roof to reduce air resistance, only SEAT-ap-
proved cross bars and roof carrier systems
can be used.
Cases in which cross bars and the roof
carrier system should be disassembled.
●
When they are not used.
●
When the vehicle is washed in a car wash.
●
When the vehicle height exceeds the maxi-
mum height, f
or example, in some garages.
WARNING
●
Al
ways secure the load properly using
belts or retaining straps that are suitable
and in a good condition.
●
Bulky, heavy, long or flat loads have a
negative effect on aerodynamics, the cen-
tre of gravity and driving performance.
148
Loading ...
Loading ...
Loading ...