EOC647S User Manual

Loading ...

WARNING

warning

USE AN AUTHORISED PERSON

As stated in the local municipal building codes and other relevant

statutory regulations.

• WiringconnectionsmustbeinaccordancewithAS/NZS

3000 Wiring Rules and any particular conditions of the

local authority.

• Refertodataplateforratinginformationandcircuitdiagram.

The data plate is positioned behind the bottom of the oven

door. The circuit diagram is positioned on the top panel of

the appliance.

• Anallpoledisconnectfunctionalswitchshouldbeprovided

near the appliance in an accessible position. Refer to AS/

NZS 3000 clause 4.3.11

• Wiringshouldbeprotectedagainstmechanicalfailure.

Refer to AS/NZS 3000 clause 3.9

• Ameansofdisconnectionwithacontactseparationofatleast

3mm must be supplied in the ﬁxed wiring.

• Togainaccesstothemainsconnectionterminals,remove

the rear panel by unscrewing the 2 assembly screws.

NOTE:Whereconnectionismadetoamulti-phase240V

supply,thebridgepieceshouldberemovedfrombetween

theactiveconnections.

WARNING

warning

IMPORTANT: This appliance must be properly earthed.

• Donotlifttheappliancebythedoorhandles.

• Preparethecupboardopeningtomatchyourappliance

measurements. (See diagrams)

• Slideapplianceintothecupboard,ensuringthatthesupply

cable (where ﬁtted) does not kink.

• Topreventtipping,usethescrewssuppliedtosecureyour

oven into the cupboard. Use just 2 screws for single cavity

ovens and 4 screws for dual cavity. Remove the bottom

door in dual cavity ovens to provide access to the bottom

2 screwing points. (See illustration page 23)

• Forappliancesttedwithasupplyexiblecord,ifthecord

is damaged, it must be replaced by the manufacturer or its

service agent or similarly qualiﬁed person in order to avoid

a hazard. The plug must be accessible after installation.

• Wheretheapplianceisbuiltintoacabinet,thecabinet

material must be capable of withstanding 70°C. Installation

into low temperature tolerant cabinetry (e.g. vinyl coated)

may result in deterioration of the low temperature coating by

discolouring or bubbling.

• Iftheapplianceisinstalledadjacenttovinyl-wrappedsurfaces,

use an installation kit available from the vinyl-wrap supplier.

• ElectroluxHomeProductscannotacceptresponsibility

for damage caused by installation into low temperature

tolerant cabinets.

• Afterinstallation,testandensurethattheapplianceoperates

correctly before handing it over to the customer.

WARNING

warning

CAUTION:Toavoidanypotentialhazard,youmustfollowour

instructionsbelowwhenyouinstallyourappliance.Failureto

installtheappliancecorrectlycouldinvalidateanywarranty

orliabilityclaimsandleadtoprosecution.

installation

22 INSTALLATION Built-in Cooking

Loading ...

User Manual - Page 22