Loading ...
Loading ...
Loading ...
Installation instructions en
37
18.2 Safe installation
Follow these safety instructions when in-
stalling the appliance.
¡ The appliance can only be used safely if it
is correctly installed according to the safety
instructions. The installer is responsible for
ensuring that the appliance works perfectly
at its installation location.
¡ Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡ Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡ Proceed in accordance with the installation
sheets for installing accessories.
¡ Fitted units must be temperature-resistant
up to 90°C, and adjacent unit fronts up to
65°C.
¡ Do not install the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.
¡ Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡ Only a licensed professional may connect
appliances without plugs. Damage caused
by incorrect connection is not covered un-
der the warranty.
WARNING‒Risk of injury!
Sharp-edged parts may be accessible during
installation.
▶
Wear protective gloves.
WARNING‒Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶
Do not use extension cables or multiple
socket strips.
▶
If the power cord is too short, contact Cus-
tomer Service.
▶
Only use adapters approved by the manu-
facturer.
18.3 Electrical connection
In order to safely connect the appliance electrically, fol-
low these instructions.
WARNING‒Risk of electric shock!
Incorrect installation is dangerous.
▶
Only a qualified electrician may route the socket or
replace a power cable while taking into considera-
tion the applicable regulations.
▶
Connect the appliance only to a correctly installed,
earthed socket.
▶
If the plug is no longer accessible following installa-
tion, an all-pole isolating unit with a contact clear-
ance of at least 3mm must be available on the in-
stallation side. Contact protection must be ensured
by the installation.
18.4 Fitted units
This appliance is only intended to be fully fitted in a kit-
chen. It is not intended to be used as a tabletop appli-
ance or within a cupboard.
The installation cabinet must not have a back panel be-
hind the appliance. Maintain a clearance of at least
35mm between the wall and the cabinet base or the
rear panel of the cabinet situated above.
The installation cabinet must have a ventilation opening
of 50cm² on the front. To do this, trim the base panel
or fit a ventilation grille. Do not cover ventilation slots
and air intake openings.
18.5 Installation in a tall unit
Observe the installation dimensions and the safety
clearances in a tall unit.
Loading ...
Loading ...
Loading ...