Loading ...
Loading ...
Loading ...
D:\WORK\VW60GB\3275583131\3275583131VPLVW200UC\010GB_
VPLVW200UC\05PRE.fm
masterpage:Left
11
Connections and Preparations
VPL-VW200
3-275-583-13 (1)
This section describes how to install the projector and screen, how to connect the
equipment from which you want to project the picture, etc.
Unpacking
Check the carton to make sure it contains the following items:
Inserting the batteries into the remote control
Caution about handling the remote control
• Handle the remote control with care. Do not drop or step on it, or spill liquid of any kind
onto it.
• Do not place the remote in a location near a heat source, a place subject to direct
sunlight, or a damp room.
Connections and Preparations
• Remote control (1)
• Size AA (R6) batteries (2)
• AC power cord (1)
• ImageDirector3 CD-ROM (1)
• Plug holder
Attach the plug holder to avoid
unplugging the AC power cord
accidentally. (1 page 14)
• Air filter cover (1)
This air filter cover is used only when
the projector is installed on a ceiling.
(1 page 78)
• Lens cap (1)
When you have purchased the projector,
the lens cap is put onto the lens.
Remove this lens cap when you use the
projector.
• Operating Instructions (this manual)
Insert the batteries E side first as shown in the illustration.
Inserting them forcibly or with the polarities reversed may
cause a short circuit and may generate heat.
Push and slide to open.
Loading ...
Loading ...
Loading ...