Loading ...
Loading ...
Loading ...
110
WARNINGWARNING
To help ensure the system proper
functioning, the sensors positioned
on the bumper must be kept clean
(remove any mud, dirt, snow or ice).
When approaching obstacles found in
front or behind the vehicle, the parking
sensors provide the driver with
information on their distance.
The driver receives information about the
presence and distance of the obstacles
both by means of acoustic signals, the
tone frequency of which increases as the
obstacle gets closer, and by means of
visual warnings on the TFT display (see
the “Carrozzeria Scaglietti” User’s
Manual).
By supplementing the driver’s direct
visual information with that provided by
the system acoustic signals and visual
warnings, potential collisions can be
avoided during maneuvers.
WARNINGWARNING
However, the driver remains fully
responsible for parking maneuvers
and in other potentially dangerous
situations. The system has been
designed only as a supplementary
aid during parking maneuvers, since
it allows the driver to detect
obstacles outside his field of vision.
Use of the sensors therefore does
not mean that the driver can be less
careful and attentive and not watch
out for persons and obstacles during
parking maneuvers.
The parking system sensors, housed in the
rear bumper, are activated automatically,
with the key at position
II, when reversing.
If the vehicle is equipped with front
sensors, these can be activated by pressing
the relative button on the center console.
When reverse gear is engaged, an acoustic
signal (beep) warns the driver that the
system is active.
The system then begins to beep as soon
as an obstacle is detected, and the tone
frequency increases as the vehicle
approaches the obstacle.
When the obstacle is located at a distance
of less than 15.7 in. (40 cm), the beep is
continuous.
The warning beep stops immediately if
the distance between the vehicle and the
obstacle increases.
The tone cycle is constant if the distance
measured by the central sensors remains
unaltered.
For the TFT display graphic configuration,
please consult the “Carrozzeria Scaglietti”
User’s Manual.
Cleaning the sensors
When cleaning the sensors, take special
care not to scratch or damage them;
therefore, do not use dry, rough or hard
cloths.
The sensors must be washed with clean
water, possibly with car shampoo added.
Loading ...
Loading ...
Loading ...