Loading ...
Loading ...
Loading ...
ADDITIONAL
INFORMATION
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
E
E
NGLISH
NGLISH
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
<ARE1349> En
51
○○○○○○○○○○○○○○○○○○○
Troubleshooting
What may at first seem to be an malfunction, may be
remedied with a quick check.
Please check to see if a warning is displayed on the
screen. If displayed, refer to page 53 and check the
mode. If there is no display check to see if the problem is
listed below. The problem may also be caused by
something other than this unit so please also check the
other components being used such as a video deck. If the
problem can still not be solved please consult the dealer
where this unit was purchased.
General problems
÷ No power.
÷ Unit cannot be operated.
÷ Remote control does not
operate.
÷ Picture is cut off.
÷ Strange color, light color, or
dark, or color misalignment..
÷ Power is suddenly turned
off.
÷ No picture.
÷ Is the power cord disconnected? (page 15)
÷ Has the MAIN POWER switch been switched on? (page 6)
÷ External influences such as lightning, static electricity, etc., may cause improper operation. In this
case, operate the unit after first turning the main power on/off, or unplugging the power cord and
re-plugging it in after 1 to 2 minutes.
÷ Are batteries inserted with polarity (+, –) correctly aligned? (page 50)
÷ Are batteries worn out? (Replace with new batteries).
÷ Is there a plug inserted in the CONTROL IN terminal?
Because reception of the remote control’s signal will not be possible if a plug is inserted, please
check connections (page 15).
÷ Is the selected screen size correct?
Switch to another screen size (pages 22 to 25).
÷ Are SCREEN mode adjustments such as picture size made correctly? (page 38).
÷ Adjust the picture tone (page 31).
÷ Is the room too bright?
The picture may look dark in a room that is too bright.
÷ The unit’s internal temperature has increased. (Air vents are blocked.)
Remove any objects blocking vent or clean (page 49).
÷ Is the POWER SAVE mode set to “MODE1” or “MODE2”? (page 2 6)
÷ Is connection to other components correct? (pages 10 to 13)
÷ Has setup been done correctly after connection? (pages 17 to 19)
÷ Is the correct input selected? (page 20)
÷ Is a non-compatible signal being input? (pages 10, 14, 55 and 56)
÷ Is picture adjustment correct? (page 31)
Problem Possible Solution
ADDITIONAL INFORMATION
Cleaning the vents
As a general rule, use a vacuum cleaner about once a
month to clean the vents on the rear panel of the display
of dust buildup (set the vacuum cleaner to its weakest
setting when doing this).
Using the unit without cleaning it of dust will cause the
internal temperature to increase, resulting in possible
breakdown or fire.
Loading ...
Loading ...
Loading ...