Loading ...
Loading ...
Loading ...
INSTALLATION
AND CONNECTIONS
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
E
E
NGLISH
NGLISH
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
<ARE1349> En
15
○○○○○○○○○○○○○○○○○○○
Power cord connection
Connect the power cord after all component connections
have been completed.
1 Connect the power cord to this unit.
2 Plug the power cord into a power outlet.
CAUTION
÷ Use only the power cord provided.
÷ Do not use a power supply voltage other than that indicated
(AC 120 V, 60 Hz) as this may cause fire or electric shock.
÷ For the plasma display, a three-core power cord with a ground
terminal is used for efficiency protection. Always be sure to
connect the power cord to a three-pronged outlet and make
sure that the cord is properly grounded. If you use a power
source converter plug, use an outlet with a ground terminal
and screw down the ground line.
○○○○○○○○○○○○○○○○○○○
Control cord connection
When control cord connections are made, remote control
operation of connected PIONEER components that bear
the Î logo mark is done through the remote sensor on
this unit.
When the connection is made to the CONTROL IN jack
on another unit, the remote sensor of that component will
no longer receive signals. Point the remote control unit of
the connected component at the remote control sensor
on this unit to control.
Notes
÷ Make sure the power is turned off when making
connections.
÷ Please complete all component connections before
making control cord connections.
INSTALLATION AND CONNECTIONS
The control cables (not
supplied) are monaural
cables with mini plugs (no
resistance).
1
2
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN OUT
Main Unit
Loading ...
Loading ...
Loading ...