Loading ...
Loading ...
Loading ...
19
STEP 10 INSTALL CONNECT CABLE
CONNECT CABLE (85)
C1
C2
C4
Threaded End Threaded End
C3
C6
C5
24
101
134
170
1
4
100
170
134
23
T10
101
170
134
25
T9
147
100
82
4
142
1. See Figs. C1 & C2 Screw the threaded end of CONNECT CABLE (85) into the SINGLE PULLEY
BLOCK (24) and route the cable up and over Pulley C2 mounted on TOP FRAME (4), using one
3/8" X 55L FLAT PIN BOLT (142) and one M6 X 12L MALE SCREW (147).
2. See Fig. C3 Route the cable down and around Pulley C3 mounted on the MAIN FRAME (1), using
one 3/8" X 1-3/4" HEX BOLT (134) and one 3/8" NYLA-NUT (170).
3. See Fig. C4 Continue to route cable up and around the Pulley C4 mounted at second hole of ADJ.
PULLEY BLOCK (23), using one 3/8" X 1-3/4" HEX BOLT (134) and one 3/8" NYLA-NUT (170).
4. See Figs. C5 & C6 Route the cable down and around Pulley C5 mounted in the top of the
DOUBLE PULLEY BLOCK (25) using one 3/8" X
1-3/4" HEX BOLT (134) and one 3/8" NYLA-NUT
(170). Finish by routing the cable up to screw into the
threaded receptor welded to the TOP FRAME (4).
Fig. C1 Fig. C2
Fig. C3
Fig. C4
Fig. C5
Fig. C6
Loading ...
Loading ...
Loading ...