Loading ...
Loading ...
Loading ...
13
STEP 5 PRESS ARM ASSEMBLY
35
4
9
38
7
56
74
160
103
190
181
160
169
103
153
158
125
158
147
184
185
185
147
184
185
102
102
147
169
184
184
184
1. Secure the PLASTIC COVER (74) to the front of the PRESS ARM SUPPORT (9) using one
M5 X 63L SCREW (153). Attach the PRESS ARM SUPPORT (9) to the TOP FRAME (4) by
aligning the holes and inserting the AXLE (35). Secure and tighten using two 1/2" LARGER
WASHERS (160) and two 1/2" NYLA-NUTS (169). Cap with two 1/2" CAP NUTS (103).
2. Attach the PRESS ARM (7) to the PRESS ARM SUPPORT (9) by aligning the holes and
inserting the PRESS ARM AXLE (38). The LONGER POP PIN (125) should seat into one of
the adjustment holes in the PRESS ARM SUPPORT (9). Secure the PRESS ARM AXLE
(38) by tightening the preinstalled 5/16" X 1/4" SET SCREW (158).
3. Attach the PRESS ARM PANEL (56) to the PRESS ARM (7) using four M6 WASHERS
(185), eight SMALL SEALING RINGS (184) and four M6 X 12L MALE SCREWS (147).
Install two END CAPS (102) into the bottom of the PRESS ARM (7) using a rubber mallet.
IMPORTANT! The washer arrangement in the next step is very important to
prevent cracking of the PRESS ARM PANEL (56). DO NOT OVERTIGHTEN!
Loading ...
Loading ...
Loading ...