Loading ...
Loading ...
Loading ...
(211,1)
北米Model "A2550BE-B" EDITED: 2019/ 1/ 16
! Malfunction of the high beam assist
function
S03AH0705
If the high beam assist function is mal-
functioning or is temporarily stopped, the
headlight will be fixed at low beam.
High beam assist warning indicator (yel-
low)
When the high beam assist function
malfunctions, the high beam assist warn-
ing indicator on the combination meter will
appear. In this case, have your vehicle
inspected by your SUBARU dealer.
! Temporary stop of high beam assist
function
S03AH0706
If the high beam assist function stops
temporarily due to poor visibility or abnor-
mal temperature, the message appears on
the combination meter. Once the condi-
tions have been remedied, drive the
vehicle for a while to restore the system.
NOTE
Even when the operation conditions of
the high beam assist function are met,
there may be a case in which the high
beam assist indicator does not illumi-
nate.
Type A:
In this case, turn the ignition switch to
the “LOCK”/“OFF” position and then to
the “ON” position again. Check if the
high beam assist indicator illuminates.
If the indicator does not illuminate,
have the vehicle inspected at a
SUBARU dealer.
Type B:
For details, refer to the Owner’s Manual
supplement for the EyeSight system.
! How to temporarily lower the sensi-
tivity of the high beam assist func-
tion
S03AH0704
The sensitivity of the high beam assist
function can be lowered by using the
following operations.
Type A:
1. Turn the ignition switch to the “ON”
position.
1) Automatic dimming on/off button
2. Press and hold the automatic dimming
on/off button for 15 to 20 seconds.
When the sensitivity of the high beam
assist function is lowered, the LED indi-
cator on the automatic dimming on/off
button will flash.
NOTE
. The sensitivity of the high beam
assist function cannot be lowered while
driving.
. You can resume the sensitivity of the
high beam assist function by using
either of the following operations.
– Turn the ignition switch to the
“LOCK”/“OFF” position and then
start the engine.
– CONTINUED –
Instruments and controls/Light control switch
3-53
3
Loading ...
Loading ...
Loading ...