Loading ...
Loading ...
Loading ...
26
TREBLE
The Intensity of the High Frequencies in the music can
be increased or decreased by using the Trim Select
and Trim Adjust Control. To make an adjustment per-
form the following:
1. Use the Front Panel INPUT/TRIM Control or the
TRIM Push-button on the Remote Control until
“TREBLE, 0 dB” appears on the Front Panel
Information Display. Refer to figure 65.
2. Rotate the VOLUME/ADJUST Control or press
the LEVEL UP / DOWN Push-buttons to increase
(refer to figure 66) or decrease (refer to figure 67)
the volume level of the high frequencies.
The Front Panel Display indicates the Treble changes
METER BACKLIGHT
The MA5300 Front Panel Meter Illumination may be
switched On or Off by performing the following:
1. Select “METER LIGHTS, On” as indicated on the
Front Panel Information Display. Refer to figures
50, 53 (on page 24) and 70.
2. Switch Off the Meter Illumination. Refer to
figure 71.
After approximately 5 seconds the Information
Display returns to indicate the Source Selection and
Volume Level.
Notes: 1. Meter Illumination of recent McIntosh Power
Amplifiers will also switch On/Off when con-
nected to the MA5300 via a power control
cable.
2. Some A/V Processors will provide an On/Off
Control Signal when the MA5300 Passthru
Input Jack is connected to the A/V Processor
via the power control cable.
INFORMATION DISPLAY ILLUMINATION
The Brightness Level of the MA5300 Front Panel In-
formation Display can be adjusted from bright to dim
by performing the following:
1. Select “DISPLAY BRIGHTNESS” as indicated
on the Front Panel Information Display. Refer to
figures 50, 53 (on page 24) and 72.
2. Reduce the Brightness level by adjusting the
TRIM LEVEL. Refer to figure 73.
in steps from +12dB to -12dB. After approximately
6 seconds the Display returns to indicate the Source
Selection and Volume Level.
MONO/STEREO MODE
By default the Stereo Mode is active for all Input
Sources however, any Input Source may be assigned
to Mono Mode. To change Stereo Mode to Mono for a
given Input Source, perform the following steps:
1. Select the desired Input Source.
2. Select “MONO / STEREO,
______
” as
indicated on the Front Panel Information Display.
Refer to figure 68.
3. To select MONO Mode adjust the TRIM LEVEL.
Refer to figure 69.
After approximately 5 seconds the Information
Display returns to indicate the Source Selection and
Volume Level.
Figure 50
How to Operate the MA5300, con’t
Figure 69
MONO / STEREO
____
Figure 68
MONO / STEREO
______
Figure 70
METER LIGHTS
On
Figure 71
METER LIGHTS
Off
Figure 65
TREBLE
0 dB
Figure 66
TREBLE
+12dB
Figure 67
TREBLE
-12dB
USB 35%
DSD256
Loading ...
Loading ...
Loading ...