Loading ...
Loading ...
Loading ...
Configure indoor model WAX610 offline
using a directly connected computer
Note: This procedure does not apply to outdoor model WAX610Y because it requires
a PoE+ connection to a PoE+ switch. (A directly connected computer cannot provide
PoE+ to the access point.)
You can take the access point offline (that is, disconnect it from your network), connect
a computer through an Ethernet cable to the LAN/PoE+ port of the access point, and
connect to the access point over its default IP address so that you can configure it offline.
After you complete the configuration, you can bring the access point online.
Note: Because the access point is not connected to a PoE+ switch, you can use this
configuration method only if you have a power adapter for the access point.
To connect to the access point using a computer that is connected to a LAN/PoE+
port of the access point:
1.
Record the IP address and subnet mask of your computer so that you can reinstate
these IP address settings later.
2. Temporarily change the IP address on your computer to 192.168.0.210 with
255.255.255.0 as the subnet mask.
(You can actually use any IP address in the 192.168.0.2–192.168.0.254 range, with
the exception of IP address 192.168.0.100, which is the default IP address of the
access point.)
For more information about changing the IP address on your computer, see the help
or documentation for your computer.
3. Use an Ethernet cable to connect your computer to a LAN/PoE+ port on the access
point.
4. On the computer, launch a web browser and enter 192.168.0.100 in the address
bar.
User Manual42Install the Access Point in Your
Network and Access It for Initial
Configuration
Insight Managed WiFi 6 AX1800 Dual Band Access Point Models WAX610 and WAX610Y
Loading ...
Loading ...
Loading ...