Loading ...
Loading ...
Loading ...
16
These chemicals will harm the unit and will damage the
cleaning surface.
Shutting Down
1. Press the On/O button on the control panel.
2. Pour the remaining water out from the bucket or turn o
the water source.
3. Hold the trigger to release water pressure.
4. If using the base unit directly, disconnect the garden hose
from the water inlet on the base unit.
5. Disconnect the high-pressure hose connection on the
trigger gun handle.
6. Release the trigger and lock the gun safety lock.
mWARNING! Turn o the water supply and squeeze the
trigger to depressurize the unit. Failure to do so could result in
personal injury due to discharge of high-pressure water.
Taking a Break
If you are taking a break between cleaning tasks:
1. Lock the gun safety lock.
2. Push the On/O button to stop the machine.
NOTE: If being kept in stand-by mode for 3 minutes, the
machine will shut o automatically.
Storage
mCAUTION! Always store your pressure washer in a
location where the temperature will not fall below 32ºF (0ºC).
The pump in this machine is susceptible to permanent damage
if it freezes. FREEZE DAMAGE IS NOT COVERED BY THE
WARRANTY.
• Store the pressure washer indoors in a dry, covered area
where it is not subject to adverse weather conditions.
• It is important to store this product in a frost-free area.
• Always empty water from all hoses, the pump, the soap
dispense attachment and the bucket before storing.
mCAUTION! The use of a pump protector is
recommended to prevent cold weather damage during storage
over the winter months.
Winterizing + Long-Term Storage
If you must store your pressure washer in a location where
the temperature falls below 32ºF (0ºC), you can minimize the
chance of damage to your machine by utilizing the following
procedure:
• Disconnect all water connections.
• Turn on the machine for a few seconds until the remaining
water in the pump exits. Turn o immediately.
• Do not allow the high-pressure hose to become kinked.
• Store the machine and accessories in a room that does
not reach freezing temperatures.
• Do not store near a furnace or other sources of heat that
may dry out the pump seals.
• Operate the pressure washer with non-corrosive/non-toxic
anti-freeze, a pump saver, or a pump protector before
storing for the winter.
mWARNING! Before reusing, completely ush the
unit out with clear water. Anti-freeze products can damage
paintwork, so you must ensure there is no anti-freeze left in the
system before using it again.
Maintenance
m
CAUTION! Before working on the pressure washer,
remove the batteries from the compartment.
1. To ensure good performance, check and clean the lters.
Remove the lters and rinse with warm water to prevent
any foreign matter from clogging the pump.
2. Remove the water bucket lid and make sure the bucket is
empty.
3. Turn the bucket lter counterclockwise to align the tabs
with the slots, and disassemble it from the water bucket
(Fig. 28).
4. Remove the bucket from the base unit. Disconnect
the bucket adapter from the water inlet by turning it
counterclockwise (Fig. 18)
5. Using pliers, remove the water inlet lter from the water
inlet (Fig. 29)
Fig. 28
Water bucket
Bucketlter
Tab
Slots
Loading ...
Loading ...
Loading ...