Loading ...
Loading ...
Loading ...
15
5. Reconnect the pressure washer with the water bucket or
the garden hose. Turn on the pressure washer. Pull the
trigger to operate the unit.
mCAUTION! Always test the detergent in an
inconspicuous area before use.
6. Apply detergent from the bottom to the top of the dry
surface to be cleaned.
NOTE: Wetting the surface rst is not recommended as it
dilutes the detergent and reduces its cleaning ability.
7. Allow the detergent to remain on the surface for a short
time before rinsing. Do not allow the detergent to dry on
the surface.
mCAUTION! Damage may occur to painted surfaces if
the detergent is allowed to dry on the surface. Wash and rinse
a small section at a time. Avoid working on hot surfaces or in
direct sunlight.
mCAUTION! Failure to follow these cleaning instructions
will cause the injection system to become clogged and
inoperable.
Rinsing with the Pressure Washer
1. Turn o the pressure washer, remove the bucket or shut
o the water supply.
2. Pull the trigger to release water pressure.
3. Push the safety lock on the trigger handle to lock it.
4. Remove the foam cannon by pushing rmly in while
twisting it clockwise to unlock the tabs and remove from
the slots. Pull the attachment out of the trigger gun.
5. Attach the spray wand and the 5-in-1 nozzle onto the
trigger gun.
6. Select the right spray pattern for the job (Fig. 27).
I) The 0º intense-jet spray pattern is an extremely
powerful , high-pressure, pencil-point jet stream.
It is used to cut heavy dirt deposits in a small,
concentrated area. It is ideal for dissolving stubborn
substances, like tar and grease spots on concrete,
or for removing caked mud from equipment. Use this
pattern to clean hard-to-reach areas including the
facades of 2-story buildings or the undersides of lawn
mowers and tractors.
NOTE: Care should be used when choosing the right
spray pattern to avoid permanently gouging wood or
damaging fragile surfaces.
II) Use the 0+ straight line pattern for home siding, brick
patios, wood decks, driveways, or sidewalks. When
using this nozzle, test a small area rst to avoid surface
damage.
III) Use the 15º spray pattern for intense cleaning jobs on
hard surfaces. Applications include stripping paint,
removing oil stains, grease, heavy mildew stains, and
rust from steel. This spray should only be used in areas
that can withstand the high-pressure from this spray.
IV) Use the 40º wide-spray pattern to clean items such as
cars, trucks, boats, patio furniture, or lawn equipment.
V) Use the 40+ pattern for light cleaning applications.
7. Lock the bucket with water on the base unit or connect
the base unit with a water supply. Start at the top of the
area to be rinsed and work your way down, making sure
to overlap your strokes.
mIMPORTANT! NEVER USE:
• Bleach, chlorine products, and other corrosive chemicals
• Liquids containing solvents (e.g. paint thinners,
gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
Fig. 26
Trigger gun
Foam cannon
Fig. 27
0º
15º
40º 0+
40+
Loading ...
Loading ...
Loading ...