Loading ...
Loading ...
Loading ...
13
7. Attach garden hose to water supply (Fig. 21).
mWARNING! Water that has owed through back ow
preventers is considered to be non-potable.
mWARNING! The water supply must not exceed 0.7Mpa.
8. If only using the base unit, turn the water supply tap
on completely.
9. Push the safety lock on the spray gun handle, then press
the trigger for a few seconds until the water ow is steady.
Operating the pressure washer in this manner will allow
air to escape and discharge residual pressure in the hose
(Fig. 22).
10. Keeping the trigger pressed, turn on the unit by pressing
the On/O button on the control panel. Using the "Pressure
Select" feature, you can also use the pressure washer in a
lower setting by pressing the
button below the ON/O
button (Fig. 23).
NOTE: This machine is equipped with 2 power/pressure levels.
When starting, the machine is set in default high power/high
pressure level. See table below for detailed specs.
11. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is operated
and shuts o when the trigger is released.
Control Panel (Fig. 24)
Fig. 20
Garden hose
Fig. 21
Connect to water supply
Garden hose
Fig. 22
Trigger
Safety lock
Fig. 23
Control panel
Power
Light
indication
Ratedow
Rated
pressure
– O
– On
High 0.65 GPM 800 PSI
– On
– On
Low 0.77 GPM 650 PSI
Fig. 24
On/Obutton
Power indicator
Low power
mode indicator
Low power
setting button
Error indicator
Loading ...
Loading ...
Loading ...