Loading ...
Loading ...
Loading ...
9
Assembly Instructions
STEP 1
Pull the factory installed wires out of the top of the
stove. There will be two wire harnesses, as shown.
STEP 2
Unpack the top mount controls and ensure that
the wiring harness shown is attached securely.
STEP 3
Connect the factory installed wiring harnesses to
the control panel as shown.
STEP 4
Attach the control panel to the top of the stove,
as shown.
STEP 5
Secure with two sheet metal screws.
PANEL CONTROLS
The blowers and automatic fuel supply are controlled from a panel on the top of this unit. The control panel functions
are a follows.
A. ON/OFF SWITCH (“POWER” BUTTON)
• When pushed, the stove will automatically ignite. No other re starter is necessary. The igniter will stay on for at
least 10 and up to 12 minutes, depending on when Proof of Fire is reached. The re should start in approximately
5 minutes.
• The red light located above the “POWER” button will turn green when pressed and remain green until the stove
is turned off.
• After pushing “POWER”, the auger motor is on for 3.5 minutes, off for 1 minute. During the remainder of the start-
up period, the auger motor operates on the heat range “1” setting.
• During start up the heat level advance (Up and Down keys) will change the heat range indicator level
accordingly, but there is no change in the stoves operating conditions until start-up is completed.
• During start-up ignition must occur within 12 minutes or the stove will error out and show E4.
• During the start-up phase, the Mode key does not function.
Control Panel
Loading ...
Loading ...
Loading ...