Loading ...
Loading ...
Loading ...
12
SYSTEM SETUP
EnglishDeutschFrançais DanskEspañolItalianoSvenska Nederlands DanskItalianoSvenska DeutschNederlands EnglishFrançais Español
Connecting the B1 bass module
You can place the B1 or B2 bass module either vertically or horizontally on the floor. It fits
neatly between the legs of the power stand.
1. Plug one end of the B1 or B2 bass module cable into one of the bass connectors. Rotate
the plug clo
ckwise to lock it in place. You should hear a soft click as it locks.
2. Plug the other end of the cable into the Bass Module Out connec
tor on the power
stand. Rotate the plug clockwise to lock it.
Note:
To disconnect a B1 or B2 cable, slide back the metal tab on the body of the plug, rotate
the plug counterclockwise, and pull it out of the connector.
Figure 5
B1 bass module
B1
Bass Module
Out
Bass Module
Out
B2
CAUTIONS:
• DO NOT connect a B1 bass module to two power stands at the same time.
• DO NOT connect any bass module other than the B1 or B2 to the power stand.
• DO NOT substitute the supplied cable with a 2-wire speaker cable. Use only the supplied
4-wire ca
ble to connect the bass module to the power stand. The power stand uses the
signals on two of the wires (or the position of the B2 rear panel switch) to automatically
sense how many bass modules are connected.
VeniceOG.book Page 12 Friday, August 31, 2012 12:18 PM
Loading ...
Loading ...
Loading ...