Loading ...
Loading ...
Loading ...
10
SYSTEM SETUP
EnglishDeutschFrançais DanskEspañolItalianoSvenska Nederlands DanskItalianoSvenska DeutschNederlands EnglishFrançais Español
Setting up the L1
®
model II power stand
1. Holding the power stand vertically on the floor (Figure 2A), grasp one leg and swing it out
as far as it will go. Notice that the other legs swing out automatically.
The legs must be fully open befor
e you can plug the L1
®
bottom section into
the power stand.
2. Lay the power stand flat on the floor in the desired position (Figure 2B).
Figure 2
Putting the power stand on
the floor
A
B
Socket for
L1 bottom
WARNING: DO NOT move the completely assembled system as a unit. This could result in
personal injury and/or damage to the product. Position the power stand on the floor in the
chosen location before assembling the system.
Assembling the L1 model II top and bottom array loudspeakers
This procedure tells you how to set up the loudspeaker sections in the power stand. If you
plan to mount the T1 ToneMatch
®
audio engine on the L1 model II system, see “Adding a T1
ToneMatch
®
audio engine (optional)” on page 12 before installing the top section of the loud-
speaker.
1. Hold the L1 bottom so that the grille faces front and plug it into the power stand (Figu
re
3A). Be sure to fully insert it into the socket to assure stability and
a good connection.
2. Align the bayonet on the L1 top with the channel on the back of the L1 bottom, and lower
the L1 to
p onto the L1 bottom until it is flush (Figure 3B).
Figure 3
Setting up the L1 model II
top and bottom arrays
L1 top
L1 bottom
Bayonet
Channel
A
B
Front of
system
VeniceOG.book Page 10 Friday, August 31, 2012 12:18 PM
Loading ...
Loading ...
Loading ...