Loading ...
Loading ...
Loading ...
26 49-60820 Rev. 2
REFRIGERATOR LOCATION
Ŷ Do not install the refrigerator where the
temperature will go below 60°F (16°C) because
it will not run often enough to maintain proper
temperatures.
Ŷ Do not install the refrigerator where the
temperature will go above 100°F (37°C) because
it will not perform properly.
Ŷ Do not install the refrigerator in a location exposed
to water (rain, etc.) or direct sunlight.
Ŷ Install it on a floor strong enough to support it fully
loaded.
CLEARANCES
Allow the following clearances for ease of
installation, proper air circulation and plumbing and
electrical connections.
6LGHV ´PP
7RS ´PP&DELQHW+LQJH&RYHU
%DFN ´PP
REMOVING THE REFRIGERATOR
DOORS
Ŷ IMPORTANT NOTE: This refrigerator is 35
1
/4´
deep (30
1
/4´IRU&<(&:(PRGHOVZLWKRXW
handles. Doors and passageways leading to the
installation location must be at least 35
1
/4´
1
/4´
for CYE, CWE models) wide in order to leave the
doors and handles attached to the refrigerator
while transporting it into the installation location. If
passageways are less than 35
1
/4´
1
/4´IRU&<(
CWE models), the refrigerator doors and handles
can easily be scratched and damaged. The top cap
and doors can be removed to allow the refrigerator
to be safely moved indoors. If passageways are
less than 35
1
/4´
1
/4´IRU&<(&:(PRGHOVVWDUW
with Step 1.
Ŷ If it is not necessary to remove doors, skip to Step
11. Leave tape and all packaging on doors until the
refrigerator is in the final location.
Ŷ NOTE:8VHDSDGGHGKDQGWUXFNWRPRYHWKLV
refrigerator. Place the refrigerator on the hand
truck with a side against the truck. We strongly
recommend that TWO PEOPLE move and
complete this installation.
REMOVE THE REFRIGERATOR
DOORS
WARNING
Follow all steps for removing
and reinstalling the door. Failure to follow these
instructions, leaving off parts, or overtightening
screws, can lead to the door falling off and result in
injury and property damage.
A
Securely tape the door shut with masking tape
or have a second person support the door.
B
Start with left-hand door first: Remove the hinge
cover on top of the left refrigerator door by
removing all hex screws and pulling it up. Do the
same for the right-hand door and the middle
cover.
C
Disconnect both
electrical connectors at
the top cover.
5HPRYHWKH´KH[
head screw to
disconnect the ground
wire from the hinge.
5HPRYHWKH´KH[KHDGVFUHZWRUHPRYHWKH
strain relief from the water line.
1
Ground
screw
Strain
Relief
Hinge
Cover
Installation Instructions
INSTALLATION INSTRUCTIONS
INSTALLING THE REFRIGERATOR
Loading ...
Loading ...
Loading ...