Loading ...
Loading ...
Loading ...
Page 8 of 24 802258UK G4 Boiling (& ambient) residential, user guide - August 2015 - V2.01
Pull both levers forward
Safety
sensor
Procedure
• Shield the HydroTap
®
G4 from any
direct sunlight.
• With the Command-Centre
TM
in
normal operating mode turn the
power off.
• Pull both tap levers to the forward
position.
• Turn the power on.
• The Command-Centre
TM
will calibrate
the safety switch.
• Return the levers to the neutral
position.
Light intensity varies from site to site, therefore it is recommended that a
recalibration be performed at the time of the installation.
All direct sunlight must be shaded from the HydroTap
®
G4, during the
calibration. This can be achieved by closing any nearby curtains, blinds, etc.
Safety sensor calibration
Tap lights
Blue lights
Red lights
Blue AMBIENT water lights (not
available on Elite).
Continually illuminated
This indicates that the temperature of the
ambient water is within the set temperature
range.
Flashing slowly
This indicates that the ambient water is not
within the set temperature range. When the
ambient water is at the set temperature, the
light will stop flashing. This could take several
minutes.
During heavy usage, the temperature can rise
out of this range.
Red BOILING water lights
all models
Continually illuminated
This indicates that the boiling water is ready.
Flashing slowly
This indicates that the boiling water is below
the set dispense temperature.
Wait for the light to stop flashing before
dispensing water. The light will typically flash
after switching on, or coming out of sleep
mode.
Loading ...
Loading ...
Loading ...