Loading ...
Loading ...
Loading ...
26
WASH CYCLE OPTIONS
Add a Garment
The ‘Add a Garment’ option enables you to add or remove items during the wash stage
of the cycle, under certain conditions. Once the ‘Add a Garment’ button is touched, the
button and time to go will flash. Wait until you hear the door unlock. Open the door
and add or remove items. Close the door and touch to restart the cycle. The ‘Add
a Garment’ button will only operate during the wash part of the cycle and when the
temperature selected is lower than 60°C. ‘Add a Garment’ can still be used if the water
level is above the bottom of the door, as your washer will drain the water to a lower
level so the door can be opened.
Keylock
This option enables you to deactivate the buttons on the display panel, except for the
‘Power’ and ‘Keylock’ buttons. This prevents accidental button presses.
To turn Keylock mode ON or OFF when the washer is powered on:
Touch and hold the button for 2 seconds.
Note: when activated, the light above the button is illuminated.
If Keylock mode is activated and the machine is powered off:
To turn your washer on, press the ‘POWER’ button, then touch and hold the button
for twoseconds. Select your wash cycle, options and then touch to start the cycle.
To turn the washer off at anytime when keylock is activated simply press the ‘POWER’
button.
Delay Start
The ‘Delay Start’ option enables you to delay the start of the wash cycle from between
5minutes and 12hours. Times you can select are 5min, 15min, 30min, 1hour, then hourly
up to 12hours. This can be useful to time your washing to finish when you arrive home
from work, or to start once you have finished in the shower. Some stain removers also
require you to spray them on then leave for several minutes, before washing. Your washer
will wait for the selected time then start the cycle without any other inputs from you.
To programme a ‘Delay Start’ time, simply touch the ‘More’ button to increase the
delay time and ‘Less’ button to decrease the time or turn ‘Delay Start’ off. Touch
to confirm your selection and start the countdown. Once started, the time will count
down on the display screen in 1 minute increments, the ‘Delay Start’ light will flash and
the light will stop flashing and be on constantly.
Note: if you hold the ‘More’ button down, the time displayed on the screen will increase
after every half second (more convenient than touching the button repetitively).
To remove a ‘Delay Start’ time once it is counting down, simply touch , then touch the
‘Less’ button to decrease the time to zero. Touch to start the cycle immediately.
Note: we suggest that you avoid using ‘Delay Start’ for damp, non-colourfast items as
this may cause dye run to occur.
Loading ...
Loading ...
Loading ...