Loading ...
Loading ...
Loading ...
Connections
N1X Owner’s Manual •39
Connection with the USB Wireless LAN Adaptor (UD-WL01*)
*UD-WL01 (sold separately) may not be available depending on your area.
There are two types of connections with the USB wireless adaptor (UD-WL01) described below.
Connecting by the Infrastructure Mode (Automatic Setup by WPS)
The Infrastructure mode uses an access point for data communication between a USB
wireless LAN adaptor and a network. You can use this mode when you connect to the
internet while connecting the wireless LAN adaptor to the instrument.
1 Connect the UD-WL01 (sold separately) to the [USB TO DEVICE]
terminal.
2 Hold down [WPS] on the UD-WL01 for three seconds.
“
§PS
” appears on the display.
3 Press the WPS button on your access point within two minutes
after step 2.
After connection to the access point is completed, the message will disappear.
4 Make sure your smart device is connected to the network to
which you connected the instrument.
If not, turn on the Wi-Fi on the Wi-Fi setting display on your smart device, and
then tap and connect to the network to which you connected the instrument.
Connecting by Access Point Mode
The Access Point mode allows you to directly connect UD-WL01 (sold separately)
and a smart device, without the need for using an access point. You can use this mode
when there is not any access point available for connection to the instrument, or when
it is unnecessary to connect to another network while a smart device is connected to
the instrument.
1 Initialize the instrument (page 34) if the last wireless LAN con-
nection was made by Infrastructure Mode.
NOTICE
The initialization procedure initializes all Backup data (page 34), with the exception of
the Character Code and Bluetooth Paring information.
2 Connect the UD-WL01 (sold separately) to the [USB TO DEVICE]
terminal.
3 On your smart device, turn on the Wi-Fi on the Wi-Fi setting dis-
play and tap “ap-N1X-xxxxxx” (“xxxxxx” represents 6 alphanu-
meric characters) to connect the instrument.
NOTE
Before using the [USB TO DEVICE] termi-
nal, be sure to read “Precautions when
using the [USB TO DEVICE] terminal” on
page 31.
Access point
An “access point” refers to a device which
acts as a base station when data is trans-
mitted/received via a USB wireless LAN
adaptor.
Some access points are combined with
router or modem functions.
NOTE
If the last wireless LAN connection was
made by Infrastructure mode, you can con-
nect to a network automatically without
executing steps 2 and 3.
n1x_en_om.book Page 39 Friday, October 19, 2018 6:01 PM
Loading ...
Loading ...
Loading ...