Loading ...
Loading ...
Loading ...
Disconnect the AC Power cord to shut Off the Unit when Trouble is found or not in Use. The AC Power cord shall
remain readily operable and available.
CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of
the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that is deemed to comply
without maximum permissive exposure evaluation (MPE).
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
WARNING: Batteries (Battery pack or battery installed) shall not be exposed to excessive heat such as sunshine, fire or the
like.
Do not place the unit on the furniture that is capable of being tilted by a child and an adult leaning, pulling, standing or climbing
on it. A falling unit can cause serious injury or even death.
This apparatus should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided.
Make sure to leave a space of 3.9 inches (10cm) or more around this apparatus.
Never use a gas duster on this unit.
The gas trapped inside of this unit may cause ignition and explosion.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
Mounting Soundbar on a Wall
The recommended screw (sold separately) allows the mounting of the Soundbar on the Wall.
Funai is not liable for any accident, damage or injury due to any improper installation, lack of strength of installation or
improper use.
Drill screw holes into the wall. Depending on the wall material, use Molly Anchor inserts to make sure the screws will not
fall out. Although the Soundbar weighs approximately 5.3 lb/2.4 kg, it is recommended that the wall be able to support 15.
9 lb/ 7.2 kg (three times the weight of the Soundbar) for extra safety. Recommended measurements are as follows: Wall
thickness of 2”/5 cm or more, Screw diameter of 5/32”/4 mm and, Screw length of 1-3/16”/30 mm or more.
Screw and Molly Anchor are sold separately and are not supplied.
Funai is not liable for these types kinds of accidents or injury noted below.
Install two screws on a sturdy vertical wall.
If installed onto a ceiling or slanted wall, the Soundbar and screws may fall which could result in a severe injury.
Do not use screws that are longer or shorter than their specified length. If screws too long or short are used this may cause
the Soundbar to fall.
Do not fasten Screw’s and Molly Anchor’s with excessive force, this may damage the Wall causing the Soundbar to fall,
leading to an injury.
Do not mount the Soundbar onto screws while the Soundbar is Plugged In or turned On. It may result in an electrical shock
injury.
When Installing the Soundbar on a Wall, allow this much space.
Top: 4”/10 cm Left and right sides: 4”/10 cm
Bottom: 4”/10 cm Space between Mounting Screw and Wall: 9/64”- 5/32”/3.5 - 4mm
To Avoid the Hazards of Electrical Shock and Fire
Do not handle the AC Power cord with wet hands.
Do not pull on the AC Power cord when disconnecting it
from an AC outlet. Grasp it by the plug.
Do not put your fingers or objects into the unit.
Location and Handling
Do not install the unit in direct sunlight, near strong
magnetic fields, or in a place subject to dust or strong
vibration.
Avoid a place with drastic temperature changes.
Install the unit in a horizontal and stable position. Do not
place anything directly on top or bottom of the unit.
Depending on your external devices, noise or disturbance of
the picture and / or sound may be generated if the unit is
placed too close to them. In this case, please ensure enough
space between the external devices and the unit.
Depending on the environment, the temperature of this unit
may increase slightly. This is not a malfunction.
Be sure to Unplug the AC Power cord from the AC outlet
before Removing the Unit.
Dew Condensation Warning
Dew condensation may form inside the unit in the following
conditions. If so, do not use this unit at least for a few hours
until its inside gets dry.
The unit is moved from a cold place to a warm place.
Under conditions of high humidity.
After heating a cold room.
Note about Recycling
This unit’s packaging materials are
recyclable and can be reused. Please
dispose of any materials in accordance with
your local recycling regulations.
Batteries should never be thrown away or
incinerated but disposed of in accordance
with your local regulations concerning chemical wastes.
For product recycling information, please visit - sanyo-
av.com
– 4 –EN
Loading ...
Loading ...
Loading ...