-
- II -
-
- IV -
-
- VI -
1. Keep away from people, animals, electrical wires, tall
buildings, airports, signal towers, and other obstacles,
to avoid interference to GNSS signals and ensure the
positioning accuracy.
2. Avoid working in extreme weather such as heavy rain,
strong wind, thick fog, snow, and lightning.
Others:
1. Do not disassemble the product without authorization,
which may invalidate the warranty.
2. Damage caused by force majeure events, such as lightning
strikes, high voltage, and collision, is not covered by
the warranty.
-
3. Use the device in strict accordance with the manual. When
connecting cables such as data cables, hold the end of
the plug and gently plug or unplug it. Do not pull the
plug by force or twist the plug, which may break the pins.
4. Use the regulated power supplies accepted by FJDynamics,
and strictly follow the rated voltages, to prevent
damaging the radio, the field controller, and the
receiver.
5. During charging, keep away from fire sources such as
flammables and explosives, to avoid fire and other
serious consequences.
6. During operation, do not power the receiver via the Type-C
interface and the aviation connector at the same time.
7. Do not plug or unplug cables when the receiver is powered
on, and replace the damaged cables in time to avoid
personal injury.
-
V10L
- 2 -
Figure 1.2
-
- 4 -
-
- 6 -
-
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 CONSUMER LASER PRODUCT
EN 50689:2021
a) This warning shall state that viewing the laser
output with telescopic optical instruments (for
example, telescopes and binoculars) may pose an
eye hazard and thus the user should not direct the
beam into an area where such instruments are likely
to be used.
b）A description of any radiation pattern(s) emitted
from the protective housing during the performance
of operation and maintenance procedures. Where
applicable, this shall include a statement in
appropriate units of:
Wavelength：520 nm±20 nm
Maximum power or energy output：0.475 mW
- 8 -
Figure 1.3 Components and interfaces
-
- 10 -
2.2.1 Setting Up the Instruments
2.2.1.1 Setting Up the Rover
-
2.2.1.2 Setting Up the External Radio
- 12 -
-
2.2.1.3 Setting up the Internal Radio
- 14 -
-
2.2.2 Connecting the Devices
Select "WiFi", find the device name starting with "GNSS"
in the WiFi device list and click on it (the initial password
is 12345678). If it displays "Connected", it means the
connection is successful.
Note:This device will not be sold to the general public, it
will be sold to dealers only.
- 16 -
-
GPS L1 C/A, GPS L1C, BDS B1I,
BDS B1C, Galileo E1, GLONASS
G1, SBAS L1: 1559-1610MHz;
GPS L2C, GLONASS G2,
Galileo E6:1215-1300 MHz;GPS
L5, Galileo E5a, Galileo E5b:
1164-1215MHz;
- 18 -
-
- 20 -
4
FSK
-
- 22 -
221 77.7 16 mm
BT/BLE
2.4G :2412-2462MHz;2422-2452MHz
5G:5150-5250MHz,5250-5350MHz,
5470-5725MHz,5725-5850MHz
-
AT BE CY CZ DK
EE FI FR DE EL
HU IE IT LV LT
LU MT NL PL PT
SK SI ES SE
BG
RO HR
AT BE CY CZ DK
EE FI FR DE EL
HU IE IT LV LT
LU MT NL PL PT
SK SI ES SE
BG
RO HR
AT BE CY CZ DK
EE FI FR DE EL
HU IE IT LV LT
LU MT NL PL PT
SK SI ES SE
BG
RO HR
For CE:
In all EU member states,operation of
5150-5350MHz is restricted to indoor use only.
FCC Warning
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. if this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
shall be installed and operated with minimum distance 20cm between the radiator& body.
