Loading ...
Loading ...
Loading ...
24| P ag e
Fuel (Gas) Conversion Instructions for RCS grills.
This should only
be performed by a licensed gas professional
Gas regulator:
Currently all grills are supplied with a gas regulator installed. When converting the gas
application you must also convert the regulator by removing the large nut on the front of the
regulator, pulling out the plastic orifice, flipping it over and re-installing it. Tighten the large nut
and you’re ready to go. (This step does not apply to the LP hose and regulator set, only the
separate regulator that comes with the grill. You must flip this plunger when converting a
propane grill from natural gas along with installing a low pressure propane hose and regulator).
In order, the regulator must be installed and converted first in order to achieve
the proper pressure to test the conversion steps 1-10 and back burner
conversion 1-3 below. To adjust the low flame setting if necessary, see next
page………
Unscrew and remove this brass cap. This exposes
the plastic plunger
Pull off and flip over the plastic plunger and
replace in the hole. Large side down converts
the regulator to LP by compressing the interior
spring.
Replace the brass cap and you are done!!!
Note: the plunger snaps in and out of the cap.
Important Note: For Locations Near Coastal Areas and Pools
#304 stainless steel materials used in the construction of your cutlass PRO series grills are highly
rust resistant, however, chlorine in the air from swimming pools or the salt from sea air may cause
surface rust to appear and even create some pitting if left on the product. Here are a few tips to
avoid this:
• Regularly wipe down the exterior surfaces with a damp cloth (micro fiber towels work
well with grain of stainless)
• Allow the surfaces to dry before installing the cover. Do not cover a damp grill
• In extreme environments apply a rust inhibitor which leaves a microscopic protective
layer on the grill
• For seasonal storage use the product referred to above, ensure the grill is dry, then
cover and secure the cover to minimize the amount of damp air getting to the
surfaces
Loading ...
Loading ...
Loading ...