Loading ...
Loading ...
Loading ...
To connect, insert the regulator inlet into the tank valve and turn the black coupler clockwise until
the coupler tightens up. DO NOT OVER TIGHTEN THE COUPLER.
After completion of assembly, make sure all appliance control valves are OFF then turn the
propane tank supply valve on and then turn the control valves on the grill to the ‘HI/IGN’ position for
approximately 5 seconds to purge the line of air out of the gas line. After 5 seconds, you may turn on the
other burners.
Inspect the gas hose before each use of the appliance. If it is evident there is abrasion or wear, or the gas
hose is cut, it must be replaced prior to the appliance being put into operation. The replacement gas
hose assembly shall be that specified by the manufacturer.
To disconnect the propane tank from the appliance, turn the tank valve off. Hold the coupler sleeve and
turn counter clockwise. The inlet line will be disengaged.
If the appliance is not in use, the gas must be turned off at the supply cylinder. Propane cylinders
must be stored outdoors out the reach of children and must not be stored in a building, garage or any
other enclosed area.
A dented, rusty, outdated or damaged propane cylinder must be replaced immediately.
Check for leaks with a soapy water solution every time the cylinder is
replaced or reconnected. All leaks must be corrected immediately.
NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS. ALL GAS CONNECTION POINTS
SHOULD BE TESTED FOR LEAKS AFTER INSTALLATION PRIOR TO FIRST USE OF THE
GAS APPLIANCE(S).
Before installing an appliance in any island cut out, make sure that the opening is not larger than the
outside frame of the appliance unit. The appliance should rest on the lip of the frame. (See cut out
recommendations on page 15).
Pay careful attention to the location of the gas line. It should be routed away from sources of heat, sharp
edges, and aggressive surfaces and should make as few bends as possible.
Ensure the gas line connection will be accessible when the appliance is installed. A safety shutoff valve is
required at this gas connection point. Before installing the grill into the island cutout, the main burner
cotter pins on the cutlass and cutlass pro series grill may be removed for convenience of service,
adjustments, and maintenance in the future. The premier series uses screws and are required.
LP Tank Requirements:
The L.P. gas cylinder must be constructed and marked in accordance with the specifications
for L.P. gas cylinders of the U.S. Department of Transportation (DOT) and designed for use with a
QCC-1 quick disconnect system only.
The cylinder must be provided with a shut-off valve terminating in an L.P. gas supply cylinder
valve outlet specified, as applicable, for connection Number QCC-1.
The cylinder must be provided with a listed overfilling prevention device. The pressure regulator must
be used. Replacement of pressure regulators and hose assemblies can be purchased from authorized
dealers.
The cylinder supply system must be arranged for vapor withdrawal. Make sure the LP cylinder has a
collar to protect the cylinder valve. Do not store a spare LP gas cylinder under on near this appliance.
Never fill the cylinder beyond 80 percent full.
12| P ag e
Loading ...
Loading ...
Loading ...