Loading ...
Loading ...
Loading ...
If flame is lifting, remove the front panel to access the burner front (air shutter)
then turn the
air shutter clockwise reducing this intake. The screw should be loosened before turning the air
shutter.
If the flame has more yellow than blue, the air shutter should be turned counter clockwise
allowing more air in. This will stabilize the flame. Make sure to tighten the screw after
adjustments are made.
In order to provide gas to the burner, the orifice must be inside the burner venturi opening.
Check to ensure that the burner is properly secured at the front and back.
Lighting Instructions
Before Lighting:
• Check gas line/hose for signs of wear, abrasion or cuts. If evidence of
deterioration is visible,
replace the part prior to use.
• If you smell gas, check for leaks. If odor continues, immediately call for service. Keep your
face and body away from the grill top when lighting.
Grill Burner Lighting
1. Open lid before lighting. Make sure all burners are in the
‘OFF’ position.
2. Push and turn burner knob to ‘HI/IGN’ position. You will hear a "Click".
3. The pilot flame will ignite at this point, lighting the main burner.
4. Continue to hold the knob in until you have ignition.
5. If there is no ignition after 2-3 seconds, turn the knob back to the “OFF” position and repeat
steps 2-4.
1.
Follow steps 2-3
2.
Place either a burning long-barrel butane lighter or a burning long-stem match near the
manual flash tube to the front of the grill at the cooking surface. For back burners, hold
the flame against the surface of the back burner.
3.
Place ignition source over flash tube then rotate grill knob to high while holding ignition over
flash tube for five seconds.
4.
If the burner does not light within five (5) seconds of turning the control knob, immediately
depress the knob and turn the control knob to off position. Wait five (5) minutes before
repeating steps 2-4 of the MANUAL LIGHTING instructions.
5.
If the burner does not light after several attempts, immediately close all gas valves and
consult an authorized service technician.
Caution: Always wait five (5) minutes for gas to clear after any unsuccessful
lighting attempts.
Manual Ignition
Rotisserie Burner Lighting
1. Open lid before lighting. Make sure all burners are in the ‘OFF’ position.
2. Be sure to remove the upper grid in the back of your grill PRIOR to lighting the rear burner!
3. Push in and hold the control knob for 5 seconds then turn the rear rotisserie control knob to
the “on” position. While there, you’ll hear the igniter “click” This should light the rear burner.
4. If you do not see the rear burner ignite, repeat step 3. You may also see the video online at
RCSGasGrills.com.
21 | P ag e
Loading ...
Loading ...
Loading ...