Loading ...
Loading ...
Loading ...
UTD2000 Series User Manual
56
Measuring one step voltage of the step signal
To measure one step voltage of the step signal, follow the steps below:
1. Press CURSOR to display the cursor measurement menu.
2. Press menu operation key F1 to set cursor type to VOLTAGE.
3. Turn the multifunction control knob to set cursor 1 at one step voltage of the step signal.
4. Press SELECT to select the cursor, then turn the multifunction control knob again to set
cursor 2 at another step voltage of the step signal.
The cursor menu will automatically display the △V value, i.e. the voltage difference of that
point. See the figure below.
Figure 12-6 Measure the voltage difference of signals by cursors
Note: When using the cursors to measure time, follow step 2 only and set the cursor type
to time.
Loading ...
Loading ...
Loading ...