Hikvision DS-K1T321EWX User Manual

Loading ...

Set RS-485 Parameters

You can set the RS-485 parameters including the peripheral, address, baud rate, etc.

Click Conguraon → Access Control → RS-485 .

Check Enable, and set the parameters.

Peripheral Type

Select a peripheral from the drop-down list according the actual situaon. You can select from

Card Reader, Extension Module, or Access Controller.

Note

Aer the peripheral is changed and saved, the device will reboot automacally.

RS-485 Address

Set the RS-485 Address according to your actual needs.

Note

If you select Access Controller: If connect the device to a terminal via the RS-485 interface, set

the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address

according to the door No.

Baud Rate

The baud rate when the devices are communicang via the RS-485 protocol.

Output Type

If you select Access Controller as the peripheral type, you should set the parameter. The device

will output the card No. or the employee ID to the access controller.

Click Save to save the sengs.

10.6.12 Card Sengs

Set Card Security

Click Conguraon → Card Sengs → Card Type to enter the sengs page.

Set the parameters and click Save.

Enable NFC Card

In order to prevent the mobile phone from geng the data of the access control, you can

enable NFC card to increase the security level of the data.

Enable M1 Card

Enable M1 card and authencang by presenng M1 card is available.

DS-K1T321 Series Face Recognion Terminal User Manual

Loading ...

Hikvision DS-K1T321EWX Value Series Face Access Terminal