Broan X24ERVE Venmar AVS X Series ERV 227 CFM 84% SRE Top ports

Installation Guide - Page 15

For X24ERVE.

PDF File Manual, 56 pages, Read Online | Download pdf file

X24ERVE photo
Loading ...
Loading ...
Loading ...
1515
For the Installer
8. RECIRCULATION AND DEFROST SETTINGS
CAUTION
Set extended defrost on all units located in climates where the outdoor temperature typically remains below -25°C
(-13°F) (i.e. Winnipeg, Regina, Quebec, Edmonton, Yellowknife, Whitehorse, Labrador City) over a 24-hour period
for several days in a row, combined with an indoor humidity of 40% or higher.
Press and hold the
MODE key for 3 seconds.
MODE
3 sec.
Two lines are flashing
to show Standby
(default configuration
setting).
The LCD screen will show one of these configurations:
OR
CONT
Recirculation arrows
are turning, rE
flashes and CONT
label appears to show
RECIRCULATION on
low speed.
OR
TURBO
Recirculation arrows
are turning, rE
flashes and TURBO
label appears to show
RECIRCULATION on
high speed.
MODE
TURBO
OR
Use MODE or TURBO key to
see all 3 configurations.
% HUM
Press % HUM key to accept chosen
configuration and go to setting defrost
cycle type.
The LCD screen will show one of these defrost cycle types:
Sd (Standard)
(factory defrost cycle setting).
When needed, the unit will
perform defrost cycle on high
speed.
NOTE: This is the defrost type
used for the data published by
HVI and ENERGY STAR®.
OR
PL (Plus)
Use this cycle in cold regions
(outdoor temperature -25°C
[-13°F] and lower). When
needed, the unit will perform
defrost cycle on high speed on
a longer period of time.
OR
dI (Discretion)
When needed, the defrost cycle
will be performed on the same
speed than the unit ventilation
speed. (e.g.: if the unit is set on
TURBO, the defrost cycle will
be done on high speed, and
if the unit is set on CONT, the
defrost cycle will be done on
low speed.
MODE
TURBO
OR
Use MODE or TURBO key
to see all 3 defrost cycle type.
% HUM
Press % HUM key to accept chosen
defrost cycle type and go to software
version display
LCD screen alternates between the house with circled
arrows and the house without arrow. The numbers under
the house are the software version number.
Press % HUM key OR
wait 10 seconds to exit
user setting menu.
% HUM
Loading ...
Loading ...
Loading ...