Loading ...
Loading ...
Loading ...
C), use the correct engine oil to make the product easier
to start. Refer to .
1. Park the product in level ground.
2. Remove the oil fill cap and dipstick and clean it with
a cloth.
3. Put the dipstick into the oil fill tube. Do not turn the
oil fill cap onto the oil fill tube.
4. Remove the dipstick. Use the gauge on the dipstick
to examine the engine oil level. If necessary, fill
engine oil until the mark “FULL” on the dipstick is
reached. Do not fill too much engine oil.
ADD FULL
CAUTION - DO
01341
5. Put the dipstick into the oil fill tube. Make sure that
the oil fill cap is fully tightened.
Note: To replace the engine oil, Refer to
To replace
the engine oil on page 30
.
To remove the lower cover
1. Lift the engine cover.
2. Remove the fastener (A) from the lower cover (B).
B
A
D
C
3. Carefully lift the lower cover (B) to release the cover
tabs (C) for the slots that taper (D).
CAUTION:
Be careful when you
lift the lower cover, there is a risk of
damage to the lower cover tabs (C).
4. Remove the lower cover.
To install the lower cover
1. Install the lower cover (B).
2. Carefully push the lower cover (B) to attach it to the
cover tabs (C) in the slots that taper (D).
B
A
D
C
CAUTION: Be careful when you
attach the lower cover, there is a risk of
damage to the lower cover tabs (C).
3. Install the fastener (A) to the lower cover (B).
4. Lower the engine cover.
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil faster to drain.
Before the engine oil is replaced, find the correct oil
temperature range.
Note: All oil must follow the recommended API
service class SG-SL.
CAUTION: Make sure that no dirt goes
into the engine when you replace the engine
oil. Dirt can cause damage to the engine.
WARNING: The engine oil is very
hot directly after the engine stops. Let the
engine become cool before you drain the
engine oil. If you spill engine oil on your skin,
clean with soap and water.
1. Park the product on a level surface.
2. Remove the lower cover. Refer to
To remove the
lower cover on page 30
.
3. Remove the dipstick.
30
2231 - 003 - 22.09.2023
Loading ...
Loading ...
Loading ...