Loading ...
Loading ...
Loading ...
c) Carefully install the belt below around the
transmission cooling fan and onto the input
pulley (F). Make sure the belt is in the belt
keeper.
d) Install the belt on the centerspan idler (E).
e) Install the belt through the stationary idler (C)
and clutching idler (D).
f) Install the anti-rotation link (B) on the right side of
the product and tighten fully.
g) Connect the clutch harness (A).
h) Make sure the belt is in all pulley grooves and in
all belt guides and keepers.
i) Install the mower. See
To remove and install the
cutting deck on page 25
Battery
To clean the battery and the terminals
Corrosion and dirt on the battery and terminals can
cause the battery to drain power.
1. Remove the terminal guard.
2. Disconnect the BLACK battery cable.
3. Disconnect the RED battery cable and remove the
battery from the product.
4. Spray the battery with water and let dry.
5. Clean the terminals and battery cable ends with a
wire brush.
6. Lubricate the terminals with grease or equivalent.
7. Install the battery. Refer to
To connect the battery on
page 12
.
To replace the battery
WARNING:
Do not short the battery
terminals. Do not let tools or other objects
touch the two terminals at the same time.
WARNING: Before you connect the
battery, remove your metal bracelets,
wristwatch bands, rings, and so on.
1. Lift the hood to a raised position.
2. Remove the terminal cover (C).
3. Disconnect the black (negative) ground cable (A) by
removing the bolt and nut.
WARNING:
The black cable
(negative) terminal must be
disconnected first.
4. Disconnect the red (positive) battery cable (B).
5. Carefully remove the battery from the product.
6. Install a new battery in the same position as the old
battery.
7. Install the terminal cover (C).
8. Connect the red (positive) battery cable (B) and
tighten the bolt and nut.
WARNING: The red cable (positive)
terminal must be connected first
to prevent sparks from accidental
grounding.
9. Connect the black (negative) cable (A) and tighten
the bolt and nut.
10. Lower the hood.
A
C
B
To connect the jumper cables
WARNING:
Risk of explosion because
of explosive gas that comes from the
battery. Do not connect the negative
terminal of the charged battery to or near the
negative terminal of the weak battery.
CAUTION: Do not use the battery of
your product to start other vehicles.
24 2231 - 003 - 22.09.2023
Loading ...
Loading ...
Loading ...