Loading ...
Loading ...
Loading ...
6. Apply petroleum jelly on the battery cables to
prevent corrosion.
7. Lower the seat pan or the engine cover.
To move the product off the skid
1. Lift the cutting deck to its highest position. Use the
lift lever.
2. Push the clutch/brake pedal down to release the
parking brake.
3. Put the freewheel control in the "Transmission
disengaged" position, refer to
Transportation,
storage and disposal on page 37
.
4. Push the product forward off the skid.
5. Remove the strap that holds the deflector protection
up against the product.
To do a check after the assembly
• Make sure that all assembly instructions are
completed.
• Make sure that no remaining parts are in the
package.
• Make sure that the battery is prepared and charged
correctly.
• Make sure that the bolts for the seat are tightened
and that the seat is adjusted correctly.
• Make sure that the tires are correctly inflated.
• For best cutting results, make sure that the cutting
deck is balanced side to side and front to rear.
Make sure that the tires are correctly inflated for a
balanced cutting deck.
• Examine the cutting deck and the drive belts. Make
sure that the drive belts are installed correctly
around the pulleys and inner part of all belt keepers.
• Examine the electrical wires. Make sure that all wires
and connections are safe.
• Make sure that the freewheel control is in
the “Transmission engaged” position. Refer to
Transportation on page 37
.
• Make sure that the engine oil is at the correct level.
• Make sure that the tank is filled with the correct type
of fuel.
• Make sure that you know the location and function of
all controls.
• Make sure that the brake system is in safe to
operate condition.
• Make sure that the Operator Presence Control
(OPC) and the Reverse Operation System (ROS)
operate correctly. Refer to
To do a check of the
operator presence control (OPC) on page 8
and
To
do a check of the reverse operation system (ROS)
on page 8
.
• Remove the air from the transmission before
first use. Refer to
To remove the air from the
transmission on page 32
.
Operation
Introduction
WARNING: Read and understand the
safety chapter before you use the product.
To fill fuel
WARNING: Gasoline is very
flammable. Be careful and refuel outdoors.
Refer to
Fuel safety on page 9
.
CAUTION: Always use correct fuel
type. Incorrect fuel type causes damage to
the product.
• Use gasoline of the correct type. Refer to
Technical
data on page 39
. For more information about the
fuel, refer to the engine manual supplied by the
engine manufacturer.
• Do a check of the fuel level before each use and
refuel if necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 1 in.
To start the product
To do before you start the product
WARNING: Before you operate the
product, carefully read and understand
the safety instructions and the operation
instructions.
1. Do a check of the engine oil level. Refer to
To do a
check of the engine oil level on page 29
.
2. Fill the fuel tank with fuel. Refer to
To fill fuel on
page 13
.
3. Disengage the freewheel mode. Refer to
To put the
product in freewheel mode on page 18
.
4. Sit in the seat in operation position.
5. Engage the parking brake. Refer to
To engage and
disengage the parking brake on page 16
.
6. Make sure that the cutting deck is disengaged. Refer
to
To engage and disengage the cutting deck on
page 17
.
To start a warm engine
1. Sit in the seat.
2231 - 003 - 22.09.2023 13
Loading ...
Loading ...
Loading ...