Loading ...
Loading ...
Loading ...
WARNING: When the rear lift links
are disconnected from the cutting deck,
the attachment lift lever is spring loaded.
Hold the attachment lift lever tightly if
you change its position.
8. Remove the cutting deck from the product.
9. Install the cutting deck in the opposite sequence.
Make sure that the discharge side is on the right
side of the product. Make sure that the drive belt
for the cutting deck is installed correctly. Refer to
To
remove the drive belt for the cutting deck on page
28
.
Note: The suspension arms must be in forward
position when you move the cutting deck below the
product.
To install the anti-sway bar
1. From the right side of the cutting deck, put the 90°
end of the anti-sway bar (A) into the hole in the
transaxle bracket (B).
A
B
D
E
C
2. Put the integrated washer end (C) of the anti-sway
bar into the hole in the rear bracket on the right side
of the cutting deck. Move the cutting deck if it is
necessary.
3. Install the washer (D) and the clip (E).
To adjust the parallelism of the cutting deck
To do a visual side to side adjustment of the cutting
deck
If the cutting height is not the same on the right and left
side of the product, the cutting height can be adjusted.
Adjust the cutting height on the side of cutting deck that
has the lower cutting height.
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Go to the side of cutting deck that has the lower
cutting height.
Note:
Some models only have left side
adjustment.
4. Adjust the cutting height with a 3/4" wrench.
A
Note: Each full turn of lift adjustment nut changes
the cutting deck height 3/16" (4.7 mm).
a) Turn the lift adjustment nut (A) to the left to lower
the cutting deck.
b) Turn the lift adjustment nut (A) to the right to lift
the cutting deck.
5. Cut some grass and examine the results. Adjust if it
is necessary.
To do a precision side to side adjustment of the cutting
deck
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Put the cutting deck in the transport position. Refer
to
To set the cutting deck in transport position or
mow position on page 15
.
4. Turn the outer blade tips to align with the cutting
deck side to side.
WARNING:
The blades on the
cutting deck are sharp and can cause
injury. Use protective gloves.
5. Measure the distance (B) from the bottom edge of
the blade to the ground on the left and right side.
B B
Note:
The distance must be the same on the 2
sides.
6. Adjust the cutting height with a 3/4 in wrench.
Note:
Each full turn of the lift adjustment nut
changes the cutting height with 3/16 in (4.7 mm).
26 2231 - 003 - 22.09.2023
Loading ...
Loading ...
Loading ...