Loading ...
Loading ...
Loading ...
27
IMPORTANT!
Failure to follow the steps in the order shown may cause the Flow Limiting Device to activate resulting
in extremely low gas flow and irregular operation
Match lighting
If the burner will not light after several attempts, then the burner
can be match lit. If you have attempted to light the burner
with the igniter, allow five minutes for any accumulated gas to
dissipate.
U-burners
Keep your face as far away from the grill as possible while
manually igniting. To manually ignite, light a butane lighter
before pushing and turning the control knob to "SEAR" of
the rightmost burner. Wait 2 seconds for gas to prime manual
ignition tube, then move lighter to 10mm in front and a little
below the hole located on the top right of the burner (Fig. 16a).
If the burner does not light in four to five seconds, turn knob off,
wait five minutes and try again.
Sear burner
Keep your face as far away from the grill as possible. To light,
place a lit butane lighter or match (match holder provided and
located in drip tray) into the gap between the grates until the
flame touches the mesh. (Fig.16b). Push and turn the knob to
“MAX”. If the burner does not light in four to five seconds, turn
knob off, wait five minutes and try again.
Improper lighting procedures can cause the LP tank flow control to activate resulting in reduced heat
output. If this is suspected the flow control will need to be reset.
Refer to the Troubleshooting section of the user guide if you encounter any difficulties lighting your grill.
See the Quick Start Guide for how to use the griddle.
1 All knobs must be in the
OFF position.
2 Attach regulator hose
assembly to the tank.
3 Open the LP tank valve.
(Two full turns min).
Resetting the flow control
Grill lighting instructions
IMPORTANT!
• Open the grill hood before lighting. Turn all knobs to “OFF”. Turn the main gas supply on. If you
smell gas, shut-off gas supply and call for customer care. Only light one burner at a time.
Pushing in on the burner knob will activate the Grill Igniter, and then turning the knob from the “OFF”
position will allow the flow of gas to the burner.
The Grill Igniter will glow orange, but there will be no clicking sound during ignition.
Push in and hold the
burner knob for two seconds. Verify that the Grill ignitor is glowing. Turn the knob counterclockwise.
Release when the burner lights. If the burner does not light in four to five seconds, turn knob "OFF"
and wait five minutes before trying again so any accumulated gas may dissipate.
FIG. 16a
FIG. 16b
USING THE GRILL
Lighting Instructions
Lighting Instructions can also be found in the grill head on the drip tray handle located underneath
the front control panel. Slide out the drip tray to make all instructions visible.
Loading ...
Loading ...
Loading ...