Loading ...
Loading ...
Loading ...
2. Lubricate with a grease gun through the nipple at the
right side, below the lower belt pulley. Lubricate until
grease comes out of the rear side of the nipple.
3. Attach the belt cover and tighten the 5 screws.
To lubricate the cutting deck
1. Remove the front cover.
2. Lubricate the 6 joints (A) with engine oil.
A
A
A
A
A
A
B
B
3. Lubricate with a grease gun through the nipple on
the pivot wheel bearings for the cutting deck (B).
Lubricate until grease comes out of the rear side of
the nipple.
Troubleshooting
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem Cause
The starter motor does not turn
the engine over
The parking brake is not applied. Refer to
To apply and release the parking
brake on page 106
.
The drive of the blades is engaged. Refer to
PTO (Power Take-Off) button on
page 94
.
A fuse is blown. Refer to
To replace the fuses on page 115
.
The ignition key is defective.
The connection between the cable and the battery is bad. Refer to
Battery safety
on page 103
.
The battery is too weak. Refer to
To charge the battery on page 115
.
The starter motor is defective.
The engine does not start when
the starter motor turns the engine
over
There is no fuel in the fuel tank. Refer to
To fill fuel on page 105
.
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburetor or fuel line.
1795 - 002 - 09.12.2022 123
Loading ...
Loading ...
Loading ...