Loading ...
Loading ...
Loading ...
9. Tighten the dipstick fully before you start the engine.
Start and idle the engine for approximately 30
seconds. Stop the engine. Wait 30 seconds and do a
check of the oil level again.
To replace the engine oil and the oil
filter R 419TsX AWD
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Do not operate the engine
for more than 1–2 minutes before you drain
the engine oil. The engine oil becomes very
hot and can cause burn injuries. Let the
engine become cool before you drain the
engine oil.
WARNING: If you spill engine oil on
your body, clean with soap and water.
1. Open the plastic cap on the end of the oil drain plug.
2. To decrease the risk of oil spill, connect a hose to
the oil drain plug.
3. Put a container below the oil drain plug.
4. Remove the dipstick.
5. Turn the oil drain plug counterclockwise and pull out
to open it.
6. Let the oil run out into the container.
7. Push the oil drain plug in and turn it clockwise to
close it.
8. Disconnect the plastic hose and put the cap on the
oil drain plug.
9. Turn the oil filter counterclockwise to remove it.
10. Lightly lubricate the rubber seal on the new oil filter
with new oil.
11. To attach the oil filter, turn it clockwise until the
rubber seal is in position, then tighten a half turn
more.
12. Fill with new oil as given in
Technical data on page
129
.
13. Start the engine and let it run at idle speed for 3
minutes.
14. Stop the engine and make sure that the oil filter does
not leak.
15. Do a check of the engine oil level. Refer to
To do a
check of the engine oil level on page 119
.
16. Fill with oil to the FULL mark on the oil dipstick.
Note:
For safe disposal of used engine oil, refer to
Disposal on page 128
.
To replace the engine oil and the oil
filter R 420TsX AWD
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING:
Do not operate the engine
for more than 1–2 minutes before you drain
the engine oil. The engine oil becomes very
hot and can cause burn injuries. Let the
engine become cool before you drain the
engine oil.
WARNING: If you spill engine oil on
your body, clean with soap and water.
1. Put a container below the oil drain plug.
120
1795 - 002 - 09.12.2022
Loading ...
Loading ...
Loading ...