Loading ...
Loading ...
Loading ...
Maintenance
Introduction
WARNING: Before you do any
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
Operation before use
Make sure that there are no fuel or oil leaks.
Clean the product. Refer to
To clean the product on page 111
.
Clean the inner surfaces of the cutting deck. Refer to
To clean the product on page 111
.
Clean the engine and the muffler. Refer to
To clean the engine and the muffler on page 111
.
Make sure that the cold air intake of the engine is not blocked. Refer to
To clean the cold air intake of the engine on
page 111
.
Make sure that the safety devices are not defective. Refer to
Safety devices on the product on page 101
.
Examine the blades in the cutting deck. Refer to
To examine the blades on page 119
.
Examine and do a test of the brakes. Refer to
To do a check of the parking brake on page 113
and
To do a check of
the forward pedal and rearward pedal on page 101
.
Do a check of the engine oil level. Refer to
To do a check of the engine oil level on page 119
.
Do a check of the transmission oil level. Refer to
To do a check of the transmission oil level on page 121
.
Do a check of the steering wires. Refer to
To examine the steering wires on page 113
.
Make sure that the high beam light and the work light operates correctly (if applicable). Refer to
To start the engine
on page 107
.
X = The instructions are given in this operator's manual. O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Maintenance First
servicing
Maintenance interval
in hours
50 100 200
Do a check of and clean hydraulic hoses and couplings. Replace if necessary. O
Do a check of the belts and pulleys. O O
Do a check of the steering chain of the inner side of the frame tunnel. O
Do an inspection, lubricate and adjust all wires. O
Make sure that the tire pressure is correct. Refer to
Tire pressure on page 116
. X X
Make sure that all screws and nuts are tightened with the correct torque. O
Lubricate the operators seat. O
Lubricate all chains. O
Lubricate the wheels and blade bearings on the cutting deck (if applicable). O O
1795 - 002 - 09.12.2022 109
Loading ...
Loading ...
Loading ...