Loading ...
Loading ...
Loading ...
Chapter 11 Waveform Record RIGOL
MSO2000A/DS2000A User’s Guide 11-13
Analysis Based on Pass/ Fail Mask
Press Analyze and select “Pass/Fail”. Then, set the templet used in analysis based
on Pass/Fail mask through the method below.
Press Range to open the following setting menus.
1. Range
Press this softkey to select “Screen” or “Cursor” for the analysis (the default is
“Screen”). When “Cursor” is selected, two gray cursor lines appear on the screen.
At this point, press Cursor A and Cursor B; then, use to adjust the
positions of the two cursor lines respectively to determine the analysis range. Or,
press CursorAB and use to adjust the positions of cursor A and cursor B at
the same time.
Note: You can press down
continuously to switch the current cursor.
2. X Mask
Press this softkey and use
to adjust the horizontal threshold and the range
is from 0.02 div to 4.00 div. During the adjustment, two curves would be
displayed to show the outline of the current mask as shown in the figure below.
Figure 11-4 Analysis Based on Pass/ Fail Mask
3. Y Mask
Press this softkey and use
to adjust the vertical threshold and the range is
from 0.04 div to 5.12 div. During the adjustment, two curves would be displayed
to show the outline of the current mask.
Outline of the Current Mask
Loading ...
Loading ...
Loading ...