Loading ...
Loading ...
Loading ...
ii900/ii910
Mode d’emploi
4
PDQ Mode™. PDQ Mode is a capture mode that detects and
locates potential partial discharges. The PDQ Mode indicates a
possible type of Partial Discharge (External, Internal, Tracking, or
Other), Pulse count indication/minute, and Phase-resolved Partial
Discharge Plot (PRPD plot).
Partial Discharge (PD). PD is a localized dielectric breakdown
that does not completely bridge the electrical insulation between
two conductors under high voltage.
PD types are classified into three main types:
• External discharge, or corona discharge, is the ionization of a
fluid, gas, or air surrounding a conductor that is electrically
charged at high voltage.
• Internal discharge occurs in voids or cavities within solid or
liquid dielectrics.
• Surface discharge tracks across the surface of different
insulation materials.
MecQ™. MecQ is a capture mode that detects and locates
potential anomalies in mechanical components as an early
identification of possible mechanical deterioration that requires
further inspection.
Power On/Off
To turn on the Imager, push and hold O >2 s.
To turn off the Imager, push
O. Tap OK to continue.
Battery
XW Warning
To prevent personal injury and for safe operation
of the Product:
• Do not put battery cells and battery packs near
heat or fire.
• Do not put in sunlight.
• Do not disassemble or crush battery cells and
battery packs.
• Remove batteries to prevent battery leakage and
damage to the Product if it is not used for an
extended period.
• Connect the battery charger to the mains power
outlet before the Product.
• Use only Fluke approved power adapters to
charge the battery.
• Keep cells and battery packs clean and dry.
Clean dirty connectors with a dry, clean cloth.
W Caution
To prevent damage to the battery:
• Do not expose battery to heat sources or high-
temperature environments such as an
unattended vehicle in the sun.
• Do not store the battery on the charger for more
than 24 hours as reduced battery life may result.
• Charge the battery for a two-hour minimum at
six-month intervals for maximum battery life.
Without use, the battery will self-discharge in
approximately six months.
• Always operate in the specified temperature
range.
• Do not incinerate the Product and/or battery.
A Li-ion battery powers the Imager. The Imager includes two
batteries for a quick-change during operation.
The battery charges on the charging base. The power supply
powers the charging base. Country-specific adapters are included.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct
.com
Loading ...
Loading ...
Loading ...