Loading ...
Loading ...
Loading ...
2.
Set basic parameter, refer to
Set Basic Parameter
.
3.
Set zooming ratio, refer to
Set Zooming Ratio
.
4.
Set object distance calibration, refer to
Set Object Distance Calibration
.
5.
Set polling plan, refer to
Set Polling Plan
.
10.16.1 Set Basic Parameter
Conî´ªgure basic parameters of the linkage tracking.
Steps
1.
Go to Smart Tracking > Basic Parameter .
2.
Check Enable Linkage Monitoring to enable the radar linkage tracking. The linkage radar
will send the target position to assist the camera in tracking.
3.
Set tracking parameters.
Detection Target
Select the type of detection target.
Installation Height
Input the installation height of the camera.
Track Timeout
Input the timeout duration of tracking. The camera will stop tracking if there is no
updated position information after this duration.
Linkage Restoring Time
Input the restoring duration of tracking. The camera will restore linkage tracking after
this duration if the tracking process has been interrupted by PTZ manual control or
presets calling.
4.
Check Enable Video Relay Tracking. When the speciî´ªc target is detected by the camera
repeatedly, the radar tracking system will switch to the video tracking. The camera will
continuously track the target based on the video detection in Tracking Duration.
Note
You can go to Smart Tracking > Polling Plan to assign optical or thermal video detection.
5.
Check Capture and Upload. The camera will automatically capture pictures of the target
according to its position and focusing/zooming quality, and then upload the pictures.
Note
For the camera that has not captured the target pictures, it will automatically capture
one target picture and upload if it receives the radar message to switch tracking targets.
6.
Check Allow Manual Focusing. You can focus the camera manually during the tracking
and won't interrupt the process.
Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
63
Loading ...
Loading ...
Loading ...