FLUKE 8845A-EFPT Fine Point Extended Test Probe Adaptor Set

User Manual for the Fluke 8845A-EFPT Fine Point Extended Test Probe Adaptor Set - Page 15

For 8845A-EFPT.

PDF File Manual, 100 pages, Read Online | Download pdf file

8845A-EFPT photo
Loading ...
Loading ...
Loading ...
Introduction and Specifications
Safety Information 1
1-5
Table 1-1. Safety Information
XW Warning
To avoid possible electric shock, personal injury, or death, read the following before
using the Meter:
Use the Meter only as specified in this manual, or the protection provided by the Meter
might be impaired.
Do not use the Meter in wet environments.
Inspect the Meter before using it. Do not use the Meter if it appears damaged.
Inspect the test leads before use. Do not use them if insulation is damaged or metal is
exposed. Check the test leads for continuity. Replace damaged test leads before using
the Meter.
Verify the Meter's operation by measuring a known voltage before and after using it. Do
not use the Meter if it operates abnormally. Protection may be impaired. If in doubt,
have the Meter serviced.
Whenever it is likely that safety protection has been impaired, make the Meter
inoperative and secure it against any unintended operation.
Have the Meter serviced only by qualified service personnel.
Do not apply more than the rated voltage, as marked on the Meter, between the
terminals or between any terminal and earth ground.
Always use the power cord and connector appropriate for the voltage and outlet of the
country or location in which you are working.
Remove test leads from the Meter before opening the case.
Never remove the cover or open the case of the Meter without first removing it from the
main power source.
Never operate the Meter with the cover removed or the case open.
Use caution when working with voltages above 30 V ac rms, 42V ac peak, or 42 V dc.
These voltages pose a shock hazard.
Use only the replacement fuses specified by the manual.
Use the proper terminals, function and range for your measurements.
Do not operate the Meter around explosive gas, vapor or dust.
When using probes, keep your fingers behind the finger guards.
When making electrical connections, connect the common test lead before connecting
the live test lead. When disconnecting, disconnect the live test lead before
disconnecting the common test lead.
Disconnect circuit power and discharge all high voltage capacitors before testing
resistance, continuity, diodes, or capacitance.
Before measuring current, check the Meter's fuses and turn OFF power to the circuit
before connecting the Meter to the circuit.
When servicing the Meter, use only specified replacement parts.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...