Loading ...
Loading ...
Loading ...
Chapter 12 Serial Bus Trigger and Decode (Optional)
325
Left swipe or to open the bus configuration menu, and the following need to be set according to
measured signal:
Source — Select the signal source of decode.
Idle Level - high and low. Select whether to display high active or low active after the signal start bit of
measured equipment.
Baud Rate — Select the baud rate that matches the signal being measured, and it can be customized.
The setting method is the same as that of UART, and will not be repeated here. As shown in Figure 12-10:
Loading ...
Loading ...
Loading ...