Loading ...
Loading ...
Loading ...
Page 19
SOAP
USING CHEMICALS (If equipped)
NOTICE
Pressure washing with volatile, ammable, or corrosive liquids could cause pressure
washer damage, re, or explosion resulting in severe injury and/or death. To avoid these
hazards, use only approved soaps and chemicals, do not attempt to pressure wash with
volatile, ammable, or corrosive liquids, and NEVER use bleach.
VOLATILE LIQUIDS
Before connecting the outboard soap injector, the
heating system needs to be cooled down by allowing
water to ow for two minutes with the burner OFF.
After the cool down, turn the engine OFF then
squeeze the trigger to RELIEVE PRESSURE.
1. Disconnect the hose reel inlet hose from the high-pressure
outlet by pulling back on the quick-connect release collar.
High-pressure
outlet
2. Pull back on the high-pressure outlet quick-connect release
collar then insert the outboard soap injector; release the collar.
3. Pull back on the outboard soap injector outlet quick-connect
release collar then insert the hose reel inlet hose; release the collar.
4. Place the ltered end of the siphon hose
into a container of soap.
5.
Insert the black nozzle into the spray wand
per the Nozzle Installation section of this manual.
NOTE: Soaps will not siphon if the black soap
nozzle is not installed on the spray wand.
6. After using soap, place the ltered end of the siphon hose into a container of clean
water and run the pressure washer drawing clean water until the system is thoroughly
rinsed. If soap or other chemicals remain in the injector or siphon hose, the injector could be
damaged. Damage from soap or chemical residue is not covered under warranty.
High-pressure
outlet
Hose reel inlet
hose
Soap
injector
Siphon
hose
Loading ...
Loading ...
Loading ...